Unboxing

The printer will arrive in a box, with a series of accessories boxes. The printer box and any accessories boxes will be on top of a pallet. Using a dolly or pallet jack, take the printer to its appropriate work area. Lower the pallet to the floor, and:

1. Carefully cut the plastic wrap.
2. Remove the External Components box and any accessories boxes from the pallet, and place them on a sturdy work surface.
3. Place the Oxygen Concentrator box on the floor nearby.
4. Remove the clips from the crate using a systematic approach. Use a flathead screwdriver to pry the metal crate fasteners from the corner.
5. To remove the L-brackets from the crate, slide the screwdriver under the end of the bracket with a break in the metal. Leverage the bracket up, one side at a time until the bracket comes free from the crate. Take the stack of brackets and set them off to the side. They will be used again to store the crate.
   

   

6. Disassemble the last removable side of the crate, remove the padding from the top and sides.
7. Remove the printer from the crate with a helper and place the printer on a stable desktop.
8. Keep and store the printer box.
    

Unbox Oxygen Concentrator

The oxygen concentrator for Envision One cDLM is shipped in a separate box.
Simply remove it from the box and set it on the floor near the printer.

Unbox External Hardware

The External Hardware box contains:

1. Material tray
2. Build platform
3. Starter kit

Unbox and set these aside for later installation.
 

Starter Kit

• Scraper 
  The main use for the metal scraper is to remove the built parts from the build platform. Apart from this, the scraper can also be used to remove material residues from the build platform.
   
• X-Acto Knife with Blade 
  Use it to cut the supports off your models as precisely as possible.
   
• Material Mixing Cards
  The supplied set of cards is ideal to clean the material tray from big cured material residues after the building process without scratching the surface. It is highly recommended that the material should be filtered after each finished job or at least every time that there is a presence of residues in the material inside the material tray.